Відео

Can it trace a wire that has 12v on it? Trying to find where a wire that has 12v on it's disconnected end is getting it's 12v from

Fantastic job

Thanks for video. Curious tho, your were getting a p1800, but the solenoid was good. So, what ultimately was the problem?

Short at to the point 10/10 job sir

end result?

So if I’m understanding your correctly the white clips things once they come detached you can’t just clip them back in with pliers? You have to replace the whole metal arm? Reason being is I replaced the motor but not the arms The I explained to my dad that the arms can not be broken and when I was screwing the 10 mm bolts down he was supposed to be holding the arm things in place but he pried it apart I KNEW RIGHR AWAY WE WERE SCREWED but he insisted that they can pop back into place well now my wipers don’t work and I explained that that was the reason why and he thinks I’m wrong! I’ve checked the wires and everything even with a multimeter and the only other option is he BROKE IT!

How to remove the cover

La pantalla del 2015 es la misma que la 2012 tiene la misma caída gracias

Just did my rear coils and shocks, front coil/shock, tierods and sway bar links on both sides. 100% listen to this man and cut off those sway bar links. I wasted an hour and took 1 nut off. I found it was easy to cut the lower sway bar link after removing the outer tie rod. My driver side camber bolts were rusted together and i was spinning the NUT AND BOLT. I needed to hit it with a blowtorch and break it forwards and reverse with a breaker bar.. My Hercules 1/2 " impact with 22mm couldn't break it. I successfully did my front and rear end today and got an alignment! Thanks man what a great video!

Thank you so much for this video! It was worth the 3 hours. (i had trouble with some clips)

Thanks!

Question??? Dose it matter what type of coolant we could put in these car??? Cuz I have a 2012 Chrysler 200lx 2.4 engine and it over heat just a lil over the middle fan work good thermostat is works good no leaks but I did notice it haves green coolant...... Would that be the reason??

Why don’t you show how you actually did it those two wires did you collect it together and then put it in there in the groove and then tighten the bolt so they’re on the same thing

What is the Model # of this item?

I have 2016 chrysler 200 2.4L 161000 km. sometime in low rpm my car 5th gear jerk & shift shock im from dubai please advise i need to replace transmission fluid or something else?

Just did this on my '13 CRV. I filled as much as I could, massaged the upper/lower hoses and topped off. Everyone says once I start the car with heater on max temp and fans, the coolant level will be sucked down. Mine slowly raised and made a mess. After cleaning the mess on the ground and down the back of my radiator and all over my fan assembly, I turned off the car, put the cap on, and drove the car for a while and the heat eventually returned. I will check the level tomorrow.

Do you have a number. Or website I got a picture with a question ?

Of course it's a T55. Why wouldn't it be. Hex bolts have failed huminity time and again but thank the lord for torx!

Thank you sir!

Great job catching the angles and inside the housing. 👍🏽

Why you didn't show how you changed the negative terminal?? That's the part I'm stuck on.

fantastic video thanks

Was going crazy looking for that dip stick. So how do I check the level?

Thank you so much! I’ve had this issue for years, and have tried multiple fixes. I’m going to give this a try ASAP

Thanks for showing these straight forward steps. I've had 3 Samsung firdges over the past years and everyone of them needed an ice maker replacement of some kind. Mine has the new setup where the top assembly comes out separately so it makes it a bit easier to pull out, but still a hassle and a sour thing to have to spend over a hundred bucks for. You showing how to release the whole assembly by pushing in with the screwdriver on the side saved me many cuss words and probably breaking something. 😀Thanks!

Do 95 Honda Civics have Electronic Battery Sensors? I have been googling and havent' found anything about this. Scotty said newer cars started to use these. Not sure what he means by newer as in what years? Thanks for any tips!

This was spot on helpful. I used a scope but it wasn't necessary. My son's smaller hand helped.

My wife just had both struts and the Right front CV shaft replaced on her 2014. Now we get lots of vibration under load at 40 and 60mph. Mechanic said the struts are aftermarket and the shaft is OEM. He said maybe the struts are the issue but i cant see that as that are not rotating.

Let’s see if your mom can play

Hey boy yo good

Thanks bro

Great peice joe 👌🏻

Thanks for sharing this. I too am always learning new things. One thing that I recently learned is to place the transmission in neutral when filling with the new fluid. Super dangerous if your vehicle is not chocked properly

Thank you sir

Where can I purchase the clips? Looks like most of them damage once ripped out.

Thank you

I read somewhere you're supposed to torque the 3 top nuts down after you put the tire back on the ground.

Thank you, this video showed me the correct way to take this apart to change my cabin filter. Much appreciated.

Great video straight to the point and good camera work.

Man I'm going in after I eat dinner. This sounds like my problem. Blessings!

Whoa... you already removed the cover for access to the drain plug... I needed that info. I've got mine jacked up and am very ready with everything needed but.... Because, my 2013 CR-V LX AWD with 5 speed transmission ... stiIl couldn't see the access panel... because it was in plain sight... because I was looking way too far back towards the center under the car. I saw the oil change access panel and took it off... I thought that must be it, guess what, no transmission plug there. For those of you who may need to know... this transmission plug access panel is directly in front of the car very front of the cowl. It's easily visible just by looking under the car, no need to crawl under it. Of course you need to get under there to loosen it and all that. It's way in the front part of the cowl. I've done one drain & fill the shaking is 85% better, still a bit at very slow acceleration at about 20 to 30 MPH. The thing was short one quart and it was an ugly brown color. I don't think the last owner ever changed this fluid or may even checked it, and they got their service done at a local Honda dealer too!

Great camera work. Thanks!

This video actually really helps

Bill Furry

Just want to say this is not applicable on my '09 Suburban LTZ. There are only 25 pins on the brown connector, no blue/brown wire, plus I probed the entire brown connector and none of the pins worked.

see I was hesitant to do this but you just gave me the green light 👍🏾 subscribed

Thanks very helpful

Thanks for the info 😊

I put the negative back together just like you showed in video put tried to start car heard a tick from battery then no power at all.Can someone help me

Download complete, Super Dad mode engaged….